Short answer
First check whether the clear coat is still there. If the paint is only faded or chalky, a thorough wash, decontamination, a polish to remove the oxidized layer and a coat of wax or sealant can bring much of the shine back. If the clear coat is cracking or peeling, polishing cannot fix it and the panel needs refinishing.
Step one: work out what you are dealing with
Old paint fails in stages, and the stage decides what is possible.
- Dull but smooth. The paint has lost gloss but feels smooth and looks even. This is the easiest case.
- Chalky or oxidized. A finger wiped across the paint comes away colored, often on the roof, hood and trunk lid. The top layer has broken down, but there is usually healthy paint beneath it.
- Clear coat failure. Patches look cloudy, white or flaky, and the clear layer is lifting at the edges. On cars with a separate clear coat this is the end of the road for polishing.
- Bare spots and rust. Primer or metal is showing. That needs repair before anything else.
Test a small, hidden area first. If polishing improves it, carry on. If it gets worse or shows primer, stop.
Step two: bring back faded or oxidized paint
- Wash properly. Use a car shampoo rather than dish soap, which strips protection. Wash from the top down and rinse often.
- Decontaminate. Paint that feels rough after washing has bonded grime on it. A clay bar or clay mitt with plenty of lubricant lifts it off so the polish works on the paint, not the dirt.
- Polish. A polish or a light compound removes the thin oxidized layer and leaves fresh paint at the surface. By hand works on small areas. A dual action machine polisher gives a more even result on a whole car and is gentler than a rotary tool in inexperienced hands.
- Go easy on edges. Paint is thinnest on panel edges and body lines. Polishing too hard there is how people burn through to primer.
- Protect it. Finish with wax or a paint sealant. Freshly polished paint has no protection, and without it the sun will start the fading again.
Old single stage paint, with no separate clear coat, often responds very well to polishing because the color itself is being refreshed. You will see color on the polishing pad, which is normal for that kind of paint.
Step three: know when it needs a respray
Polishing removes a little paint every time. It cannot add any back. If the clear coat has peeled, the paint is cracked, or rust is coming through, the honest fix is refinishing: sanding the panel down, treating any rust, priming and spraying new color and clear coat. On an old car it is common for only the roof, hood and trunk to need it, because they take the most sun. That work is covered under car painting and refinishing.
If the paint problems come with rust and old dents across the car, it becomes part of a bigger job, and what is the average cost of a full car restoration explains what goes into planning one. The auto body restoration guide covers how paint and rust age together.